Descrizione
You can assemble your BRACCIO in a multitude of ways. Because it is designed for versatility, the BRACCIO can also support various objects on the end of the arm. The included BRACCIO shield allows you to hook up the servos directly to your Arduino board.
It is recommended to power the board via the jack connection with a regulated 5 VDC @ 5000 mA power supply provided in the box.
There is an on-board voltage regulator for higher voltages that protect the Braccio shield. NOTE: The protection doesn’t work for the Arduino Yun if you put the bridge between Vin and 5V on the Arm Robot Shield V1 (greater version of are called Braccio shield and has a power switch on the top of the shield).
CARATTERISTICHE TECNICHE:
- Plastic Parts x 21
- Screws x 63
- Flat Washer x 16
- Hexagon Nut x 7
- Springs x 2
- Servo Motors: 2 x SR 311, 4 x SR 431
- Arduino compatible Shield x 1
- Power Supply 5V, 5A x 1
- Phillips Screwdriver x 1
- Double Hexagon Box Wrench x 1
- Spiral Cable Protection Wrap x 1
- Weight 792 g
- Maximum operating distance range 80 cm
- Maximum Height 52 cm
- Base Width 14 cm
- Gripper Width 90 mm
- Cable length 40 cm
- Load Capacity
- Maximum weight at 32 cm operating distance: 150 g
- Maximum weight at the minimal Braccio configuration: 400g
- SpringRC SR431 – Dual Output Servo
- Control Signal PWM Analog
- Torque 4.8V: 169.5 oz-in (12.2 kg-cm) 6.0V: 201.4 oz-in (14.5 kg-cm)
- Weight 2.19 oz (62.0 g)
- Dimentions 1.65×0.81×1.56 in (42.0×20.5×39.5 mm)
- Speed 4.8V: 0.20 sec/60° 6.0V: 0.18 sec/60°
- Rotation Support Dual Bearings
- Gear Material Metal
- Rotation Range 180°
- Connector Type J (aka Futaba)
- SpringRC SR311
- Control Signal PWM Analog
- Torque 4.8V: 43.13 oz-in (3.1 kg-cm) 6.0V: 52.86 oz-in (3.8 kg-cm)
- Weight 0.95 oz (27.0 g)
- Dimentions 1.23×0.65×1.13 in (31.3×16.5×28.6 mm)
- Speed 4.8V: 0.14 sec/60° 6.0V: 0.12 sec/60°
- Rotation Support Dual Bearings
- Gear Material Metal
- Rotation Range 180°
- Connector Type J (aka Futaba)
